Category Archives: electronics

Operational Amplifiers

Posted on by

Op Amps (Operational Amplifiers) are composed of two inputs, an output, and positive and negative power supply pins.

Op Amps can be used in many different set-ups, among them being: Voltage Comparators, Inverting and Non-inverting amplifiers, Summing amplifiers, and Difference amplifiers.

In Op Amps, the voltage of the output is dependent on the voltages of the two inputs. If the Inverting input is higher, the output will be the same as the negative supply. If the Non-Inverting input is higher, the output will be the same as the positive supply.

Pins 2, 3, 4, 6, and 7 are the only pins which need to be connected to the circuit in order to use the Op Amp.

LM741 Operational Amplifier actual viewop amp schematic

RGB LEDs

Posted on by

RGB LEDs consist of three LEDs (Red, Green, and Blue). They’re all self-contained within the same plastic casing and share either a common anode, or a common cathode.

RGB LED (Common cathode)

Due to the differences in electrical characteristics, a larger resistor is needed in series with the red than that of the green and blue.

Approximate values of: 150Ω, 100Ω, 100Ω are suitable with a 5 volt supply.

The Basics – Volts and Amps

Posted on by

All circuits require an electric current to work, this is the flow of electrically charged particles. The rate at which current flows through a circuit is measured in amps.

In order for current to flow, there needs to be a potential difference between two points. This is measured in volts. If the positive terminal of a battery is 5v and the negative terminal is 0v, the potential difference is 5v. As long as the potential difference is above 0, current will flow.

basics

Diodes

Posted on by

Overview

A diode is a semiconductor which has two terminals: an anode and a cathode. They are composed of two layers of semiconducting material, one side doped to make it an N-type semiconductor, and the other doped to make it a P-type semiconductor. The anode is on the side of the P-type, and the cathode is on the side of the N-type.(More information about types of semiconductors can be found here: ‘https://tphelectronics.com/2016/09/30/semiconductors/‘).

One of the main characteristics of diodes is that they only allow current to flow in one direction. This means that they can be used to filter out alternating current, or even rectify it with the use of a diode bridge.

 

Configurations

They’re used both in forward bias, and reverse bias. This refers to the direction in which current flows (forward being anode to cathode, and reverse being cathode to anode).

When forward biased no current flows through the diode until more than the minimum voltage is applied (This is because of the depletion region). This means that it can be used to filter out voltages below this value (e.g noise). The value itself is dependent on the type of diode.

When reverse biased only a few nanoamps flow through the diode.However, If the voltage applied is too large, it’ll cause the diode to breakdown. In most cases this will destroy the diode, but the breakdown in zener diodes do not destroy it (this is used to regulate voltage).

diode-diagram-label

 

MOSFETs (Metal Oxide Semiconductor Field Effect Transistor)

Posted on by

Explanation of the acronym  

MOSFETs are a type of transistor. ‘Metal Oxide’ refers to the fact that it consists of a metal conductor, ‘Silicon’ states the material of the semiconducting layer, and ‘Field Effect’ refers to how the current flowing through the semiconductor is controlled.

Operation 

An electric field places a charge onto the gate of the MOSFET, this controls the the amount of current flowing through the semiconductor. Current flows from the drain terminal to the source terminal.

n-channel-mosfetp-channel-mosfet